How To Connect Canon Ts3122 Printer To Wifi Without Wps. In the run box, type control panel and select ok. The wps button is the one you’re looking for.
Tap start, and then select connecting to a computer/smartphone. Hold down the windows key and type r. Use the or button (b) to select [ wireless lan setup ].
Press The [ Setup ] Button (A) On The Printer.
Depending on your operating system, you may need. When connection to the wireless router is complete, and (c) will be lit. Open an internet browser and type in 192.168.*.* (the default address for most printers) choose yes when prompted about whether or not you want to continue printing over a wireless connection.
I Tried Wifi And Ran Down The Insturctions Unitil It Told Me To Push The Wps Button On My Router.
To use your printer over a wireless connection, your wireless router must already be set up. Threaded back to the wifi or usbi set up page and went through the usbi set up. This should cause the printer to print out the required wireless setting information for the printer, including the wps pin code.
The Wps Button Is The One You’re Looking For.
Set up a connection with the printer without using software. It didn't say much but it did say that the wireless lan is disabled. For about 5 seconds, press the wps.
In The Run Box, Type Control Panel And Select Ok.
(b) the computer to be used with the printer must be connected to the network. Setting up your wireless canon pixma ts3120. That button should be pressed.
Only Do This If The Green Light Is Blinking).
When i initially tried to load the driver and go through the set up pages, i got to a point where it asked me if i wanted to go wifi or usbi set up. Press and hold the wps button on the wireless router within 2 minutes. The network connection setup is now complete.
